Precautions for storage of LED display

In many cases, we cannot install the LED display screen immediately after purchasing it because of some factors. In this case, we need to store the LED display screen well. LED display, as a precision electronic product, has high requirements for storage mode and environment. It may be the result of LED display damage if you are not careful. Today, let’s talk about how to store LED display correctly.
GOB LED Display

The following eight points should be noted when storing LED display:

(1) The place where the box is to be placed shall be cleaned and laid with pearl wool.

(2) LED display screen shall not stack modules randomly or more than 10 pieces. When the modules are stacked, the lamp faces are placed relative to each other and pearl cotton is used for isolation.

(3) It is recommended to place the LED display box horizontally with the lamp facing up. If the number is too large, special attention should be paid to protection when it needs to be placed vertically. It is prohibited to place it vertically at places with large vibration.

(4) The display screen box should be handled with care. When it lands, the rear side should land first, and then the lamp surface should land, to avoid bruises.

(5) All workers must wear cordless anti-static bracelets during installation or maintenance.

(6) Anti static bracelet for LED display installation

(7) When transporting the box, it shall be lifted and shall not be pushed or dragged away on the ground to avoid damage to the bottom module caused by uneven ground. The box shall be balanced during lifting, and shall not swing or rotate in the air. The box or module shall be installed with care and shall not be thrown.
GOB LED Display

(8) If the LED display screen product needs to be adjusted, use a soft rubber hammer to strike the metal part of the box. It is strictly prohibited to strike the module. It is forbidden to squeeze or collide between modules. In case of abnormal gap and positioning, it is strictly prohibited to use hammer and other hard objects to knock the box and module. You can pick up the box and try again after removing foreign matters.


Post time: Oct-29-2022